关于“Connect Cloud Run Functions”的评价

Akshat D. · 已于 over 1 year前审核

Mayra V. · 已于 over 1 year前审核

intéressant

franz l. · 已于 over 1 year前审核

As a standard practice with regards to using the active console/shell I open it in a separate tab. I do this because its easier to follow the execution results of the individual commands required from the lab. Also, it allows me to open multiple tabs whenever I encounter a long running command (e.g. deploy a new cloud function) and thereby continue the subsequent lab steps (setup a new folder for a cloud function and then deploy it also) while the initial active console/shell command executes to completion. However, I have noticed that I am frequently getting 'the connection to your Google Cloud Shell was lost' errors. Reconnecting to the active console after this error has the effect of opening a brand new shh session; all previous temporary and environment variables are wiped, including the gcloud project/region/zone config. All these variables need resetting before being able to continue with the lab. Its bad enough when this happens once or twice. When it happens three or more times it makes the lab almost unworkable. This is extremely frustrating. Why does the active console dropout like this? The amount of rework required to re-establish all the necessary variables makes any lab instruction that suggests validating your work e.g. by verifying a new VM/firewall instance has been created through the Console UI practically a death sentence for your active console. Why bother leaving your active console even for a few seconds when you have no trust that it will remain active until you get back? Especially when you need to spend another 5 mins setting your variables up again? Meanwhile the lab timer is constantly ticking down? I hope there is a way to review and rework this situation; it does not lead to a good experience at all.

Edward C. · 已于 over 1 year前审核

Nutullah K. · 已于 over 1 year前审核

Addison A. · 已于 over 1 year前审核

good

Santhosh G. · 已于 over 1 year前审核

Daniel M. · 已于 over 1 year前审核

Nate S. · 已于 over 1 year前审核

Sachini S. · 已于 over 1 year前审核

Aaron D. · 已于 over 1 year前审核

Henry F. · 已于 over 1 year前审核

CYRIL C. · 已于 over 1 year前审核

good

Christian B. · 已于 over 1 year前审核

Chris W. · 已于 over 1 year前审核

Niclas F. · 已于 over 1 year前审核

Alessio B. · 已于 over 1 year前审核

David M. · 已于 over 1 year前审核

Anel Z. · 已于 over 1 year前审核

Christian T. · 已于 over 1 year前审核

Could deploy pubsub-function, kept getting: ERROR: (gcloud.functions.deploy) ResponseError: status=[403], code=[Ok], message=[Permission denied on 'locations/europe-west4' (or it may not exist)]

Jason H. · 已于 over 1 year前审核

Tahsin Can Ü. · 已于 over 1 year前审核

Osvaldo Guadalupe L. · 已于 over 1 year前审核

sara y. · 已于 over 1 year前审核

Andres C. · 已于 over 1 year前审核