关于“Hello Node Kubernetes”的评价

Tomasz G. · 已于 almost 6 years前审核

Robert S. · 已于 almost 6 years前审核

Need to change from "kubectl run hello-node \ --image=gcr.io/PROJECT_ID/hello-node:v1 \ --port=8080" to : kubectl create deployment hello-node --image=gcr.io/qwiklabs-gcp-00-7acc4a02b458/hello-node:v1

Ryan Hoon H. · 已于 almost 6 years前审核

several commands do not work as described. kubectl run does not create a deployment but a pod, so all the following does not work if a deployment is not manually created. The dashboard and scaling seems to have problems as well.

Christian W. · 已于 almost 6 years前审核

unable to connect 8080 port, i followed instructions and didnt work

miguel r. · 已于 almost 6 years前审核

The kubectl run command did not create a depoyment. I had to create one before the rest worked

Ludovic L. · 已于 almost 6 years前审核

Muhammad Fikri Bill G. · 已于 almost 6 years前审核

some this worng in instruction

Pubudu D. · 已于 almost 6 years前审核

Gabriela G. · 已于 almost 6 years前审核

Raul S. · 已于 almost 6 years前审核

Atichat P. · 已于 almost 6 years前审核

Kritsadanshon S. · 已于 almost 6 years前审核

Out of date on kubectl run. In version 1.18 it will create only a pod, not a deployment.

Bogdan D. · 已于 almost 6 years前审核

Naoto K. · 已于 almost 6 years前审核

Christopher M. · 已于 almost 6 years前审核

和久 神. · 已于 almost 6 years前审核

Sean s. · 已于 almost 6 years前审核

Yulian -. · 已于 almost 6 years前审核

Perhaps k8s commands have changed as below does not launch a "deployment". kubectl run hello-node \ --image=gcr.io/PROJECT_ID/hello-node:v1 \ --port=8080

Mike W. · 已于 almost 6 years前审核

Divyang D. · 已于 almost 6 years前审核

astrid b. · 已于 almost 6 years前审核

Cristina S. · 已于 almost 6 years前审核

Nikita Z. · 已于 almost 6 years前审核

Isabella T. · 已于 almost 6 years前审核

Didac G. · 已于 almost 6 years前审核