Configuring Network Connectivity Center as a Transit Hub のレビュー

Collazo Roberto · 5ヶ月前にレビュー済み

Hi there. This is a great lab with many steps to pass through. Unfortunately I believe to have found an inconsistency as described below. The initial steps, while configuring the subnets, the subnet a define the region west for the subnet a and east for subnet b. In the sequence, while launching the VMs, the regions are inverted, requiring the VM a to be located at east and VM b located in west. Since the subnets have inverted regions, the check does not pass the validation.

Catalan Rodrigo · 5ヶ月前にレビュー済み

Cruz Fred · 5ヶ月前にレビュー済み

Snijtsheuvel Terence · 5ヶ月前にレビュー済み

Agarwal Bharat · 5ヶ月前にレビュー済み

cravansola cyril · 6ヶ月前にレビュー済み

s eyalvanan · 6ヶ月前にレビュー済み

Rathi Ankur · 6ヶ月前にレビュー済み

Step 2: Create a virtual machine in vpc-a VPCs have different zones, but in this lab, one particular one was marked.

Kruk Aliaksei · 6ヶ月前にレビュー済み

Wrong region/zone for the the creation of VM vpc-b-vm-1. It should show the ping before the NCC setup and after the NCC setup instead.

Darren Darren · 6ヶ月前にレビュー済み

LI CHANG HSU · 6ヶ月前にレビュー済み

There is an error in the last step with the creation of vpc-vm-b in the selection of the zone.

del Dedo Martín · 6ヶ月前にレビュー済み

Sheriff Adekoya Adedeji · 6ヶ月前にレビュー済み

Collazo Roberto · 6ヶ月前にレビュー済み

Kushimo Tunde · 6ヶ月前にレビュー済み

Collazo Roberto · 6ヶ月前にレビュー済み

Allen Christopher · 6ヶ月前にレビュー済み

after setting up the tunnels and bgp configuration, the verify progress button doesnt recognize even though all the connections are established. The vm configurations are wrong when configuring the vm instance in vpc-b

Güner Ertan Can · 6ヶ月前にレビュー済み

Gutierrez Carlos · 6ヶ月前にレビュー済み

the second vm should be "us-west1" , not "us-east1"

李 端 · 6ヶ月前にレビュー済み

Tylec Adrian · 6ヶ月前にレビュー済み

The wrong vpc is indicated in the creation of the second VM.

Mahe Josselin · 6ヶ月前にレビュー済み

Ramanauskas Donatas · 6ヶ月前にレビュー済み

Guntupalli Venkata Girish · 6ヶ月前にレビュー済み

That was a busy lab without much margin for error. I did have a problem with VM 2 creation. The lab instructions had the same zone as VM 1, which was not correct. Consequently, there was no subnet in the region. Once I entered the correct zone for VM 2, it worked fine.

Enright Michael · 6ヶ月前にレビュー済み