Configuring Network Connectivity Center as a Transit Hub avis

Hi there. This is a great lab with many steps to pass through. Unfortunately I believe to have found an inconsistency as described below. The initial steps, while configuring the subnets, the subnet a define the region west for the subnet a and east for subnet b. In the sequence, while launching the VMs, the regions are inverted, requiring the VM a to be located at east and VM b located in west. Since the subnets have inverted regions, the check does not pass the validation.

Rodrigo C. · Examiné il y a 5 mois

Fred C. · Examiné il y a 5 mois

Terence S. · Examiné il y a 5 mois

Bharat A. · Examiné il y a 5 mois

cyril c. · Examiné il y a 5 mois

eyalvanan s. · Examiné il y a 5 mois

Ankur R. · Examiné il y a 6 mois

Step 2: Create a virtual machine in vpc-a VPCs have different zones, but in this lab, one particular one was marked.

Aliaksei K. · Examiné il y a 6 mois

Wrong region/zone for the the creation of VM vpc-b-vm-1. It should show the ping before the NCC setup and after the NCC setup instead.

Darren D. · Examiné il y a 6 mois

CHANG HSU L. · Examiné il y a 6 mois

There is an error in the last step with the creation of vpc-vm-b in the selection of the zone.

Martín d. · Examiné il y a 6 mois

Adedeji S. · Examiné il y a 6 mois

Roberto C. · Examiné il y a 6 mois

Tunde K. · Examiné il y a 6 mois

Roberto C. · Examiné il y a 6 mois

Christopher A. · Examiné il y a 6 mois

after setting up the tunnels and bgp configuration, the verify progress button doesnt recognize even though all the connections are established. The vm configurations are wrong when configuring the vm instance in vpc-b

Ertan Can G. · Examiné il y a 6 mois

Carlos G. · Examiné il y a 6 mois

the second vm should be "us-west1" , not "us-east1"

端 李. · Examiné il y a 6 mois

Adrian T. · Examiné il y a 6 mois

The wrong vpc is indicated in the creation of the second VM.

Josselin M. · Examiné il y a 6 mois

Donatas R. · Examiné il y a 6 mois

Venkata Girish G. · Examiné il y a 6 mois

That was a busy lab without much margin for error. I did have a problem with VM 2 creation. The lab instructions had the same zone as VM 1, which was not correct. Consequently, there was no subnet in the region. Once I entered the correct zone for VM 2, it worked fine.

Michael E. · Examiné il y a 6 mois

Timothy L. · Examiné il y a 6 mois