리뷰 Implementing a Hub and Spoke using NCC개

Mochamad R. · 11개월 전에 리뷰됨

Joseph C. · 11개월 전에 리뷰됨

Task 5 doesn't work

Paweł T. · 11개월 전에 리뷰됨

Instructions are not clear about the spokes' names

Pablo F. · 11개월 전에 리뷰됨

Rahiman s. · 11개월 전에 리뷰됨

Could not get the final check to be successful, even though all the connectivity seemed to work fine. There were no other details on how to correct this. Many details are assumed.

Erik L. · 11개월 전에 리뷰됨

Laxman T. · 11개월 전에 리뷰됨

instructions are not clear as the previous lab, some of them are confusing the topology tool section is poor in instructions

Werner S. · 11개월 전에 리뷰됨

Samuel G. · 11개월 전에 리뷰됨

Manuel P. · 11개월 전에 리뷰됨

Manuel P. · 11개월 전에 리뷰됨

Sajid A. · 11개월 전에 리뷰됨

Viacheslav K. · 11개월 전에 리뷰됨

Lab fails validation on task 5

Paul L. · 11개월 전에 리뷰됨

Instructions are not clear. Last check is also not configured correctly.

Anand V. · 11개월 전에 리뷰됨

Last step does not work

David C. · 11개월 전에 리뷰됨

Henrik V. · 11개월 전에 리뷰됨

task 5 not working properly

Namit S. · 11개월 전에 리뷰됨

for task6: purpose is to test connection. can not proceed for completion as it wants to have an "internal connection" created for 2 spokes. there is no clear outlined steps for this.

Karen Lacuna A. · 11개월 전에 리뷰됨

Tahar J. · 11개월 전에 리뷰됨

Smotth and steady

Vitaliy B. · 11개월 전에 리뷰됨

Nguyen D. · 11개월 전에 리뷰됨

Instructions were confusing when the NCC hub was created, the actual page didn't request for a hub. Finally, the last step was not validated correctly, even when ping command ran successfully and a connectivity test passed

Mario R. · 11개월 전에 리뷰됨

Could not get the final check to be successful, even though all the connectivity seemed to work fine. There were no other details on how to correct this. Many details are assumed.

Erik L. · 11개월 전에 리뷰됨

Lizbeth Berenice M. · 11개월 전에 리뷰됨