리뷰 Configuring Network Connectivity Center as a Transit Hub개

eyalvanan s. · 6개월 전에 리뷰됨

Ankur R. · 6개월 전에 리뷰됨

Step 2: Create a virtual machine in vpc-a VPCs have different zones, but in this lab, one particular one was marked.

Aliaksei K. · 6개월 전에 리뷰됨

Wrong region/zone for the the creation of VM vpc-b-vm-1. It should show the ping before the NCC setup and after the NCC setup instead.

Darren D. · 6개월 전에 리뷰됨

CHANG HSU L. · 6개월 전에 리뷰됨

There is an error in the last step with the creation of vpc-vm-b in the selection of the zone.

Martín d. · 6개월 전에 리뷰됨

Adedeji S. · 6개월 전에 리뷰됨

Roberto C. · 6개월 전에 리뷰됨

Tunde K. · 6개월 전에 리뷰됨

Roberto C. · 6개월 전에 리뷰됨

Christopher A. · 6개월 전에 리뷰됨

after setting up the tunnels and bgp configuration, the verify progress button doesnt recognize even though all the connections are established. The vm configurations are wrong when configuring the vm instance in vpc-b

Ertan Can G. · 6개월 전에 리뷰됨

Carlos G. · 6개월 전에 리뷰됨

the second vm should be "us-west1" , not "us-east1"

端 李. · 6개월 전에 리뷰됨

Adrian T. · 6개월 전에 리뷰됨

The wrong vpc is indicated in the creation of the second VM.

Josselin M. · 6개월 전에 리뷰됨

Donatas R. · 6개월 전에 리뷰됨

Venkata Girish G. · 6개월 전에 리뷰됨

That was a busy lab without much margin for error. I did have a problem with VM 2 creation. The lab instructions had the same zone as VM 1, which was not correct. Consequently, there was no subnet in the region. Once I entered the correct zone for VM 2, it worked fine.

Michael E. · 6개월 전에 리뷰됨

Timothy L. · 6개월 전에 리뷰됨

Timothy L. · 6개월 전에 리뷰됨

Kulsi B. · 6개월 전에 리뷰됨

Waldemar S. · 6개월 전에 리뷰됨

VasanthaKumar K. · 6개월 전에 리뷰됨

too much to do in too little time, can't learn like this unless the lab is done twice

Surya Prakash G. · 6개월 전에 리뷰됨