Getting Started with Table Calculations and Offsets in Looker Reviews

Surya A. · Reviewed over 3 years ago

Ramanathan S. · Reviewed over 3 years ago

Kamila G. · Reviewed over 3 years ago

Thomas B. · Reviewed over 3 years ago

Harshini M. · Reviewed over 3 years ago

Roxana T. · Reviewed over 3 years ago

Justin F. · Reviewed over 3 years ago

Andrew W. · Reviewed over 3 years ago

Felician E. · Reviewed over 3 years ago

Jesukpego Romeo T. · Reviewed over 3 years ago

Jeroen K. · Reviewed over 3 years ago

Snehal P. · Reviewed over 3 years ago

Again, the steps asked to save your dashboard at the end of every step do not correspond with the options you are presented with in the Lab environment. In the assignment, you are asked to save the dashboard, however, in the Looker lab environment, you get presented with 'Save to a new dashboard' or 'Save to an existing dashboard'. I had to use save to an existing dashboard to get the points for verifying the assignment. Also, the assignment reads 'Add > table calculation', but the Looker test environment says 'Add calculation' on the right hand side of the Data bar. This is confusing for users who follow the instructions literally.

Björn B. · Reviewed over 3 years ago

Tomoki S. · Reviewed over 3 years ago

Tatjana B. · Reviewed over 3 years ago

Md R. · Reviewed over 3 years ago

Some directions don't match with the actual options provided

Sujay S. · Reviewed over 3 years ago

Dimensions Columns don’t exist anymore

Siumara A. · Reviewed over 3 years ago

Good!

Andres A. · Reviewed over 3 years ago

Andres A. · Reviewed over 3 years ago

brittney m. · Reviewed over 3 years ago

Sarah D. · Reviewed over 3 years ago

Laura E. · Reviewed over 3 years ago

Vincenzo D. · Reviewed over 3 years ago

Did not check my results correctly

Taru v. · Reviewed over 3 years ago