Building Transformations and Preparing Data with Wrangler in Cloud Data Fusion Reviews

the total disk gb quota was too low so I had an error when I was running the pipeline. I searched on stackoverflow and found a solution but this lab does not work properly anymore

Zach B. · Reviewed over 3 years ago

Phil G. · Reviewed over 3 years ago

Vitaliya M. · Reviewed over 3 years ago

G S. · Reviewed over 3 years ago

Aidan H. · Reviewed over 3 years ago

Muhammed M. · Reviewed over 3 years ago

I followed the same instruction, but I got 203 errors while the pipeline execute.

Tony C. · Reviewed over 3 years ago

"Once the BigQuery sink has been placed on the canvas, connect the Wrangler node with the BigQuery node. Do this by dragging the arrow from the Wrangler node to connect to the BigQuery node as illustrated below." - You need to clear this stage that place BigQuery from Sink not from source.

Tony C. · Reviewed over 3 years ago

Tony C. · Reviewed over 3 years ago

Iza K. · Reviewed over 3 years ago

I got there eventually but the bit at the start of "Task 6 Ingestion into BigQuery" was very confusing trying to find my project. I ended up creating a new one but this wasn't clear from the instructions.

Jonathan G. · Reviewed over 3 years ago

Lou Angeline O. · Reviewed over 3 years ago

Steve C. · Reviewed over 3 years ago

Serhii S. · Reviewed over 3 years ago

Allan F. · Reviewed over 3 years ago

Dalibor G. · Reviewed over 3 years ago

Devdoot R. · Reviewed over 3 years ago

Hamid-Reza K. · Reviewed over 3 years ago

Hamid-Reza K. · Reviewed over 3 years ago

DS S. · Reviewed over 3 years ago

Simona P. · Reviewed over 3 years ago

Giovanni Daián R. · Reviewed over 3 years ago

DS S. · Reviewed over 3 years ago

Samuel J. · Reviewed over 3 years ago

Its a very technical tool and not as easy to use for non teckies as some others I have used. I created a pipeline without any errors but it failed to run at the end. Disappointing to say the least.

Mark O. · Reviewed over 3 years ago