关于“在 Cloud Data Fusion 中使用 Wrangler 构建转换和准备数据”的评价

the total disk gb quota was too low so I had an error when I was running the pipeline. I searched on stackoverflow and found a solution but this lab does not work properly anymore

Zach B. · 已于 over 3 years前审核

Phil G. · 已于 over 3 years前审核

Vitaliya M. · 已于 over 3 years前审核

G S. · 已于 over 3 years前审核

Aidan H. · 已于 over 3 years前审核

Muhammed M. · 已于 over 3 years前审核

I followed the same instruction, but I got 203 errors while the pipeline execute.

Tony C. · 已于 over 3 years前审核

"Once the BigQuery sink has been placed on the canvas, connect the Wrangler node with the BigQuery node. Do this by dragging the arrow from the Wrangler node to connect to the BigQuery node as illustrated below." - You need to clear this stage that place BigQuery from Sink not from source.

Tony C. · 已于 over 3 years前审核

Tony C. · 已于 over 3 years前审核

Iza K. · 已于 over 3 years前审核

I got there eventually but the bit at the start of "Task 6 Ingestion into BigQuery" was very confusing trying to find my project. I ended up creating a new one but this wasn't clear from the instructions.

Jonathan G. · 已于 over 3 years前审核

Lou Angeline O. · 已于 over 3 years前审核

Steve C. · 已于 over 3 years前审核

Serhii S. · 已于 over 3 years前审核

Allan F. · 已于 over 3 years前审核

Dalibor G. · 已于 over 3 years前审核

Devdoot R. · 已于 over 3 years前审核

Hamid-Reza K. · 已于 over 3 years前审核

Hamid-Reza K. · 已于 over 3 years前审核

DS S. · 已于 over 3 years前审核

Simona P. · 已于 over 3 years前审核

Giovanni Daián R. · 已于 over 3 years前审核

DS S. · 已于 over 3 years前审核

Samuel J. · 已于 over 3 years前审核

Its a very technical tool and not as easy to use for non teckies as some others I have used. I created a pipeline without any errors but it failed to run at the end. Disappointing to say the least.

Mark O. · 已于 over 3 years前审核