Como criar transformações e preparar os dados com o Wrangler no Cloud Data Fusion avaliações

the total disk gb quota was too low so I had an error when I was running the pipeline. I searched on stackoverflow and found a solution but this lab does not work properly anymore

Zach B. · Revisado há over 3 years

Phil G. · Revisado há over 3 years

Vitaliya M. · Revisado há over 3 years

G S. · Revisado há over 3 years

Aidan H. · Revisado há over 3 years

Muhammed M. · Revisado há over 3 years

I followed the same instruction, but I got 203 errors while the pipeline execute.

Tony C. · Revisado há over 3 years

"Once the BigQuery sink has been placed on the canvas, connect the Wrangler node with the BigQuery node. Do this by dragging the arrow from the Wrangler node to connect to the BigQuery node as illustrated below." - You need to clear this stage that place BigQuery from Sink not from source.

Tony C. · Revisado há over 3 years

Tony C. · Revisado há over 3 years

Iza K. · Revisado há over 3 years

I got there eventually but the bit at the start of "Task 6 Ingestion into BigQuery" was very confusing trying to find my project. I ended up creating a new one but this wasn't clear from the instructions.

Jonathan G. · Revisado há over 3 years

Lou Angeline O. · Revisado há over 3 years

Steve C. · Revisado há over 3 years

Serhii S. · Revisado há over 3 years

Allan F. · Revisado há over 3 years

Dalibor G. · Revisado há over 3 years

Devdoot R. · Revisado há over 3 years

Hamid-Reza K. · Revisado há over 3 years

Hamid-Reza K. · Revisado há over 3 years

DS S. · Revisado há over 3 years

Simona P. · Revisado há over 3 years

Giovanni Daián R. · Revisado há over 3 years

DS S. · Revisado há over 3 years

Samuel J. · Revisado há over 3 years

Its a very technical tool and not as easy to use for non teckies as some others I have used. I created a pipeline without any errors but it failed to run at the end. Disappointing to say the least.

Mark O. · Revisado há over 3 years